Readme file for SP0963 - Windows 3.1 Display Driver Support for WD24A2 
 Graphics Controller ver 1.06 
--------------------------------------------------------------------------

    This is the Windows 3.1 Driver Support Diskette for WD24A2 
    Graphics Conroller board.


    You must exit Windows before continuing with this process.


    Softpaq Diskette Build Instructions
    ----------------------------------

    1.  Obtain a formatted 1.44MB diskette.

    2.  If Softpaq obtained on diskette, copy the Softpaq file to a
        temporary directory on the hard drive and go to that directory:

            MD C:\CPQ
            COPY A:\SP0963 C:\CPQ
            C:
            CD \CPQ

        If Softpaq downloaded from BBS, go to the directory where
        downloaded to:

            C:
            CD \CPQ

    3.  From that drive and directory, run the Softpaq utility to
        unbind the primary files.

            SP0963   (and press ENTER)

        The following files should have been created:


            QRST5.EXE
            README.TXT

    4.  Create the diskette image by running this command at the
        DOS prompt:

            QRST5   (and press ENTER)

    5.  The "Choose the Transfer Type..." prompt appears.

            Choose the highlighted, default selection "All diskettes in
            the Set" by pressing ENTER.

    6.  The "You will need to have the specified number of each type(s)
        of pre-formatted media..." prompt appears.  It is asking for one
        1.44MB diskette.

            Verify that you have a formatted 1.44MB diskette and press
            ENTER to accept and continue.

            Important - Only a 1.44MB diskette can be used, other types
            of media cannot be substituted.

    7.  The "Create diskette #1, insert a 1.44 Mbyte diskette into
        drive [A] or [B]" prompt is given.  (Either A or B will be
        included in the prompt, depending on where your 3.5" diskette
        drive is located.

            If the drive shown in the prompt is not the one you wish to
            use, change the value by pressing either A or B.

            At this point, you can optionally print a label (if your
            printer is attached) by pressing F5.

            Verify that the rom family and date displayed on the screen
            for the sample label is the same as on the header for this
            document.  If not correct, press ESC to abort program.

            To begin diskette creation, press ENTER.

    8.  A counter box will be displayed during creation showing status.
        The number of cylinders will count up to 80.

    9.  When QRST5 has completed, it will exit back to DOS with the
        message:

            "QRST5: Transfer Completed"

    10. At this point, the Driver Support diskette has been created 
        and is ready to use for upgrading the graphics.

    11. Please read the README.TXT file before installing this new
        driver.